You may have one or more of the following issues :
APY are not loading
Transactions are stuck pending for more than 10 minutes
Transactions are not found on Blockscout or Etherscan
You cannot connect your wallet to one of our site
Other similar problems
Those issues are usually a symptom of a problem with Metamask itself. You can usually fix it by using one of the solution below:
Restarting your browser
Switch ETH networks and back.
In MetaMask go to Settings->Advanced->Reset Account
Disable/re-enable the meta mask plugin
All you need is to follow this tutorial.
In Metamask, scroll down to the bottom of assets and click "add token", then "custom token".
Input these token address depending of the token and network you are currently :
BAO (ETH) : 0x374CB8C27130E2c9E04F44303f3c8351B9De61C1
BAO (xDai) : 0x82dFe19164729949fD66Da1a37BC70dD6c4746ce
BAO.cx (xDai) : 0xe0d0b1DBbCF3dd5CAc67edaf9243863Fd70745DA
An other way on xDai to add a token to a wallet is to :
Go to your wallet/address on https://blockscout.com/poa/xdai/
Click the token dropdown and select your desired token
Click the MetaMask icon next to the contract address
No, the omnibridge works only with ERC20 tokens. wETH is an ERC20, you can bridge that instead.
Main net fees are high but if your gas fee is much higher than you expect it could be due to a problem cause by having too little ETH in your wallet. The deposit transaction will use roughly 198,730 gas.
It will estimate the fee at around 298,095 gas as a precaution for gas limit.
The withdraw transaction takes 124,809 gas if you are in the shorted bracket, and estimates 209,713 gas.
If you have less ETH than (gasprice * gas estimate) then the estimate breaks and continues to show higher numbers.